Quiz

Question 1

Which of the following commands show the configured CDP timers? (select two)

1. R1# show cdp

2. R1# show cdp traffic

3. R1# show cdp interface

4. R1# show cdp neighbors

Solution

1. R1# show cdp

1. R1# show cdp interface

Question 2

Which of the following commands represent the default CDP state? (select two)

1. R1(config)# no cdp run

2. R1(config)# cdp holdtime 120

3. R1(config-if)# cdp enable

4. R1(config)# cdp timer 60

Solution

1. R1(config-if)# cdp enable

1. R1(config)# cdp timer 60

Question 3

You issue the show lldp entry SW1 command on R1. R1's neighbor SW1 is a multilayer switch. What do you expect to see in the 'system capabilities' field of the output?

1. System Capabilities: B

2. System Capabilities: B,R

3. System Capabilities: S

4. System Capabilities: S,R

Solution

1. System Capabilities: B,R

Question 4

Which of the following statements about LLDP are true? (select two)

1. LLDP only operates on Cisco devices.

2. Interface Tx and Rx operations are enabled separately.

3. LLDP messages are sent every 60 seconds by default.

4. LLDP can be used to learn the ODPF setting of a neighboring device.

5. LLDP can be used to learn the VTP settings of a neighboring device.

6. LLDP can be used to learn the OS version of a neighboring device.

Solution

1. Interface Tx and Rx operations are enabled separately.

1. LLDP can be used to learn the OS version of a neighboring device.

Question 5

Which interface on R2 is SW2 connected to?

1. G0/0

2. G0/1

3. G0/2

4. G0/3

Solution

1. G0/1